The PolyPro Knock-Down Flat Wall form is the next generation of PolySteel versatility and innovation. Now create wall widths from 4” to 24” and beyond with this lightweight composite tied form.

Ease of Use
Knock-Down design provides easy transportation to and from the job, safer storage, and efficient on-site installation.

Strength
Composite ties every 6" combined with reinforced concrete and the industry's largest attachment stud creates a superior total wall solution for any residential or commercial project.

Flexibility
From 4" to 24" and beyond, you can create any size wall in 2" increments with the unique PolyPro extender. Multiple Rebar Cradles provide easy installation in the field and a full spectrum of design options.

Faster Installation
2'x4' panels install 50%-100% faster than most other ICFs. Panels are easy to cut and assemble on the jobsite.

Efficient
Form ties 6" on center reduces jobsite waste and creates a stronger form during concrete placement.

Cost Effective
Lower pricing combined with reduced freight costs, and a labor-saving design, makes you more competitive on every job.

A typical 2500 sq. ft. project will use only 200 PS·4000 forms compared to 300 standard ICF's.

That's 100 less forms!
 

Optimum Sizing  
The 24" height provides for 8 sq. ft. of wall area installed with each form, making installation
50%-100% faster than most other ICF's.

PolyPro K/D Form Tie
Knock-Down design provides for wall widths from 4" to 24" and beyond with the unique PolyPro extender.

Tongue-and-Groove Design
This PolySteel standard provides for easier wet sets, panelized wall sections, and reversibility, to simplify and speed installation, and fully integrates PolyPro with the PolySteel PS4000 series form.

Recessed Attachment Studs              
Clearly marked for alignment. The 23-1/2" tall and 1-1/2" wide recessed attachment stud allows for the easy and secure attachment of any type of interior or exterior wall finish.

Pacific PolySteel, LLC 1-671-483 POLY (7659)

Pacific PolySteel